So I've been flying since december with my Phantom 3 Pro, with no issues at all, except for the past week or two. Ive noticed at times my screen will randomly become this Magenta color, almost as if the camera is using some weird filter. Along with this, the image sometimes becomes distorted with stripes, usually green. I toggle between camera and video mode, and even reset camera setting There are currently three versions of the drone available. The Phantom 3 Professional (which I review here) shoots video in 4K (3,820x2,160-pixel) resolution and retails for $1,259, £1,159 or AU I am hoping someone can help me. This is my first drone and I cannot get the RC to link with the aircraft. I updated the firmware on the aircraft. I was not able to figure out how to update the firmware on the RC. I don't know if it even needs to be updated. It would not work when I tried. I put the same firmware on the SD card that I used for updating the aircraft (I deleted the text file Phantom 3 Pro camera tilt dial not working. I know this has been asked before but I am still not able to get the tils dial to work. It worked for the first couple flights then after a firmware update if stopped working. I just updated to the newest firmware 1.06.00 and still not working. Everything else works as it should, just not the tild dial. DJI 4K Camera for Phantom 3 Professional Quadcopter. (31) $49.99 New. DJI Part 95 2312a Clockwise Motor for Phantom 3 Standard. (7) $29.75 New. DJI Phantom 3 Part 106 Center Board Compartment Hobbies. (3) $20.00 New. If the GPS is disconnected, then no amount of reseting or recalibrating things not related to the GPS receiver is going to reconnect it. Either your GPS unit is busted or disconnected. Try looking at and if it's not connected then reconnect it. If it is connected, you'll need to replace the GPS receiver. 2018-1-25. Processing imagery from the Mavic 3 Multispectral, Phantom 4 Multispectral, Skydio S2, S2+, X2, X2E, X10, MicaSense, SenseFly, or the WingtraOne is officially supported. RTK processing from DJI drone image sets not taken in DroneDeploy can be processed on Individual plans and above. Using Map Engine does not require any app, just data. Ensure that both the aircraft and remote controller is powered off. Insert the SD card into the SD card slot on the Phantom 3 camera. Next power on the aircraft. The firmware upgrade will begin automatically after your quadcopter is powered on. It will take roughly 25 minutes to complete the firmware update. 3K0i.